Common faults of sand washer and troubleshooting methods

During the use of the sand washing machine, some failures will inevitably occur. There are many factors that cause the sand washing machine to malfunction. Here, let's talk about the common failures of the sand washing machine and the corresponding troubleshooting methods, so as not to cause shutdown and delay the construction period; 1. the output of the sand washing machine is reduced or the sand is leaked:
Causes 1. Sand net is damaged; 2. Sand net fixing bolts fall off;
Removal method 1. Inspect, repair or replace the sand net; 2. Fasten the bolts;

2. Frame vibration;
Reason 1. Loose bolts of the connecting frame; 2. Loose bolts of the bearing block
Exclusion method 1. Tighten the bolts; 2. Check and tighten the bolts; 3.Gears are easily damaged;
The reason was not maintained in time; 2. The shaft of the sand washer and the low-speed shaft of the reducer did not reach the required parallelism;
Elimination method 1, refuel at the prescribed time; 2, adjust to meet the requirements;

4. the transmission part is noisy:
Cause 1. Insufficient gear lubrication; 2. Change in gear pitch;
Remedy 1. Add sufficient grease; 2. Adjust and tighten the anchor bolts of the reducer; 5. Bearing wearing parts;
Cause 1. Oil cut or seal damage; 2. Long-term lack of maintenance and cleaning;
Removal method 1. Refuel or replace the seal ring according to regulations; 2. Regular cleaning;